OMRON
Home >> Products >> OMRON >> Power/other peripheral devices >> Power Supply >> Switching power >> S8JD Series | OMRON Switching Mode Power Supply S8JD Series

S8JD Series | OMRON Switching Mode Power Supply S8JD Series


OMRON S8JD Series Product information and technical parameters:
Brand: OMRON
Name: Switching Mode Power Supply
Model: S8JD Series
Low investment and high efficiency, shocked the market.
350W single group output switching power supply.
Protection type: short circuit / over current / over voltage / over temperature.
Forced air cooling with built-in DC fan.
PWM control and adjustment.
Cooling fan switch control.
Low cost, high reliability.

Control supply voltage: 110/220 VAC; With voltage fluctuation compensation.
Operating current: 0.25 to 0.5 A.
Accurate Detection of Heater Element.
Burnout Regardless of Heater Capacities.
Accurately detects a burned heater element or elements incor,
porated by a molding machine or packing machine and outputs,
an alarm signal OMRON S8JD Series.
Precisely singles out the burned element even if one heater el,
ement among several heater elements has been burned out S8JD Series
Applicable to small- to large-capacity heater elements.
All K2CU-F large-capacity, built-in current transformer models,
work with both single-phase and three-phase heaters.
Voltage fluctuation compensation function eliminates false,
alarms due to variations in the supply voltage OMRON S8JD Series. Type: Normal wiring.
Cable length L: 2.0 m.
Connect Connector-Terminal,
Block Conversion Units (XW2@) to,
I/O Units for Programmable,
Controllers with one touch. Time specification: Inverse type.
Current setting range: 2 to 8 A.
Operating voltage: 100/110/120 VAC.
Resetting method: Manual.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase) OMRON S8JD Series.
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frrequency, and load conditions S8JD Series. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Type: Cable with Connectors on Both Ends (RJ45/RJ45).
Category: Cat.6a .
CCable sheath material: LSZH S8JD Series.
Cable color: Green.
Cable length: 10 m.
Cables and Connectors for,
EtherCAT® and Other Industrial,
Ethernet Networks.


...More relevant models >>>>
Related model