XS2F-G422-G80-F | OMRON Single side socket connector XS2F-G422-G80-F

Cable: With no cable.
Connector: Y-Joint Plug/Socket.
Cable length: --.
Minimum order: 10.
Round Water-resistive Smartclick.
Connectors That Reduce Installation Work.
A newly developed lock mechanism that is compatible with round M12 connectors.
Simply insert the Connectors, then turn them approximately 1/8 of a turn to lock OMRON XS2F-G422-G80-F.
A positive click indicates locking.
Features the same degree of protection (IP67) as M12 connectors XS2F-G422-G80-F
A full line-up of models is planned.
Connectors with Cables are UL approved. Input points: 4.
Cable length L:2000mm.
DC 4 wire type (self diagnostic type).
The I/O sensor connector for centralized wiring,
And the province of the number of processes, strong environmental resistance as the goal,
The outer control relay box OMRON XS2F-G422-G80-F.
Compact and strong centralized wiring trunk box conforming to IP67.
The corresponding sensing I/O connector mode proximity switch, limit switch,
Photoelectric switch.
With the power to show LED, action shows LED.
The installation dimensions are the same and are not related to the number of input points,
Therefore, the addition of a simple exchange OMRON XS2F-G422-G80-F.
A series of sensors with self diagnostic features are added to the product. Cable: With cable.
Connector: Connectors on both cable ends.
Cable length L: 0.5 m.
Minimum order: 5.
Small Round Water-resistive.
Connectors.
Water-resistive, compact connector meets IP67 requirements.
Conventional M8 screw-mounting models are available along with,
S8 snap-in models that connect and disconnect with one touch.
Ideal for a wide variety of FA and OA applications.
Connectors on both cable ends require no harness work.
Some new M8 models with 3 or 5 poles. Measuring current: 10 to 100 A AC, 20 to 200 A (See note.).
Supply voltage: 100-115 VAC.
Ideal for current monitoring for,
industrial facilities and equipment.
Monitor for overcurrents or undercurrents.
Manual resetting and automatically resetting supported by one Relay. XS2F-G422-G80-F.
Startup lock and operating time can be set separately.
One SPDT output relay, 6 A at 250 VAC (resistive load).
Output relay can be switched between normally open and,
normally closed.
Process control signal (4 to 20 mA) and coommercial CT input,
(0 to 1 A or 0 to 5 A) supported XS2F-G422-G80-F.
Output status can be monitored using LED indicator.
Inputs are isolated from the power supply.