OMRON
Home >> Products >> OMRON >> Power/other peripheral devices >> Common socket / DIN guide / waterproof cover >> PYF14S | OMRON Screwless Clamp Terminal Sockets PYF14S

PYF14S | OMRON Screwless Clamp Terminal Sockets PYF14S

OMRON PYF14S Manual And Instructions
PYF14S datasheetPDF datasheet

OMRON PYF14S Product information and technical parameters:
Brand: OMRON
Name: Screwless Clamp Terminal Sockets
Model: PYF14S
Applicable model (typical example): MY4.
New Screwless Terminal Sockets Added.
for MY and G2R Relays.
Simplified wiring without tightening screws.
Two wires can be independently wired for each terminal.
Coil terminals and contact terminals are completely separated,
in an organized wiring layout.
Release Levers and Nameplates are available (sold separately).

Time specification: Inverse type.
Current setting range: 20 to 65 A.
Operating voltage: 100/110/120 VAC.
Resetting method: Automatic (See note.).
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage OMRON PYF14S.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase PYF14S
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions OMRON PYF14S. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Type: Flat Cable.
Terminal Block: Terminal block with M3.5 screws.
Connector: Flat Cable Connectors*1.
No. of poles: 60.
Simplifies Connector and terminal,
block replacement, and requires less,
in-panel wiring OMRON PYF14S.
Mount to DIN Track or via screws.
MIL Flat Cable Connectors and Multi-pole, Square,
Connectors are standard.
Terminal blocks available with either M3 or M3.5 screws.
Connecting Cables for Programmable Controllers,
available (sold separately). Ideal for Monitoring 3-phase Power.
Supplies for Industrial Facilities and Equipment.
Greater resistance to inverter noise.
Monitor overvoltages, undervoltages, phase sequence,
aand phase loss for three-phase 3-wire or 4-wire power,
supplies with just one Unit PYF14S.
Switch setting for 3-phase 3-wire or 3-phase 4-wire power supply.
Two SPDT output relays, 5 A at 250 VAC (resistive load).
Output overvoltages and undervooltages using separate relays PYF14S.
World-wide power specifications supported by one Unit (switchable).
Output status can be monitored using LED indicator.


...More relevant models >>>>