OMRON E3Z-G61-M3J Manual E3Z-G61-M3J INSTRUCTION sheet

A small, high resolution general type of hollow shaft with no need for coupling.
Incremental diameter (38 hollow shaft).
With 8 shaft hole.
Corresponding supply voltage DC5 ~ 24V (open collector output type).
Outer diameter of 38, with high resolution 3600P/R.
Power supply voltage: DC5 ~ 24V.
Output form: open collector output (NPN output) E3Z-G61-M3J INSTRUCTION sheet.
Sensing method: Through-beam E3Z-G61-M3J
Connection method: Pre-wired (2 m).
Sensing distance: 25 mm.
No. of opti- cal axes: 2.
Model: NPN output.
Photoelectric Sensor with Grooved.
Design and Easy Settings .
Groove-type Sensor with groove width of 25 mm.
Models are available with one or two light axes.
Models are available with M8 pre-wired connectors E3Z-G61-M3J INSTRUCTION sheet. Appearance: Shielded, M18.
Sensing distance: 7 mm.
Output configuration: DC 3-wire (PNP).
Operation mode: NO.
Proximity Sensor Ideal for the Food and Beverage Industry. Appearance: 6.5 dia.
Sensing distance: 4 mm.
Connecting method: M8 Connector Models.
Cable specifications: --.
Operation mode: NO.
Wire color /pin arrangement: 1: +V, 3: 0 V, 4: Control output.
Model: NPN output E3Z-G61-M3J INSTRUCTION sheet.
Ultra small size, but surprisingly easy installation!
With the addition of M4, 5.4-dia., 6.5-dia. size, unshielded,
pre-wired connector model, and connector model, a total of,
108 model variations are available.
High-speed response frequency stably detects moving,
objects: 5 kHz max.
Four indicator lamps for easier indicator positioning.
Special mounting brackets reduce time and efforts for,
installation.
Protective Stainless-steel Spiral Tube against wire,
breakage is available (M4, M5 only).
Models also available with standard cables that are 5 m long,
or with robot (bending-resistant) cables. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: current output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: -.
Event input points: -.
Transfer output: output (using control output).
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV E3Z-G61-M3J Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E3Z-G61-M3J Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.