OMRON GRT1-OD4G-3 Manual GRT1-OD4G-3 REFERENCE MANUAL

Cable /G79-Y_C with loose wire connecting terminal.
L size: 3000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Insulation method: Phototriac coupler.
Zero cross function: Yes.
Indicators: Yes(See page 5) GRT1-OD4G-3 REFERENCE MANUAL.
Rated output load: 20 A, 100 to 240 VAC (resistive load: AC, Class1) GRT1-OD4G-3
Refer to Safety Precautions for All Solid State Relays.
Detects failures in SSR used for heater,
temperature control and simultaneously,
outputs alarm signal. This SSR supports the,
safe design of heater control systems, and,
contributes to maintenance improvements by the user.
Main detection items:
SSR short-circuits and SSR open-circuits,
Alarm output possible to NPN/PNP-input devices GRT1-OD4G-3 REFERENCE MANUAL.
The failure-detection function is built-in and power is supplied,
from the main circuit power supply making wiring simple.
Slim design (width: 22.5 mm) incorporating a heat sink.
In addition to screw mounting, DIN track mounting is also possible.
Certified by EC, UL, and CSA. Contact configuration: Four SPST-NO relays GRT1-OD4G-3 REFERENCE MANUAL.
Heat sink: No.
Built-in SSRs: G3S-201PL-PD.
Zero cross function: No.
Applicable output load: 0.6 A at 75 to 264 VAC(See note 1.).
Rated voltage: 5 VDC, 12 VDC, 24 VDC.
Compact Terminal SSR with 4 Outputs.
Easy-to-use SSR block that combines four compact G3S SSRs,
sockets, and heat sink in one unit.
Easy wiring with separate I/O terminal construction.
LED operation indicator.
Special socket used for easy Relay replacement.
Mounts either on DIN track or with screws. Control terminal block: Screwless clamp terminal block.
Type: Standard.
Capacity: 20 A, 100 to 240 VAC.
Heater burnout detection: No.
Communications: No.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control. GRT1-OD4G-3 Manual.
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,,
and constant-current control GRT1-OD4G-3 Manual.
Application with various loads: constant load resistance,
variable load resistance.
UL, and IEC/EN (TÜV) certified.