OMRON CS1W-NC113 Manual CS1W-NC113 Installation Guide

NO. OF I/O SLOTS: 5 SLOTSModel: C200H-DA004.
Input points: 8.Model: CPM2A-60CDT-D. Power supply: DC power supply.
Output type: Transistor sinking.
Inputs points: 36 points.
Outputs points: 24 points.CVM1-CL Accessory MODULE, CONTROLLER LINK, 62.5FIB CVM1-CLK52.Inputs: 8.Output method: Relay.
Inputs: --- CS1W-NC113 Installation Guide.
Outputs: 16.Model: CPM2C-20EDR. Units with 20 I/O points.
1 I/O terminal block CS1W-NC113
Inputs: 12 inputs.
Outputs: 8 outputs.
Input type: 24 VDC.
Output type: relay.For 8-slot Backplane.Unit type: CJ1 Basic I/O Units.
Product name: Transistor Output Units.
Specifications: Output type, Sourcing;
I/O points, 64 outputs;
Maximum switching capacity, 12 to 24VDC, 0.3A;
Commons, 16 points, 1 common;
External connection, MIL connector CS1W-NC113 Installation Guide.
No. of words allocated: 4 words.
Current consumption: 5V, 0.17A; 24V, --.
Standards: UC1, N, L, CE.
A Wide Range of Basic Output,
Units for High Speed Output,
and Different Applications.
These Output Units receive the ,
results of output instructions ,
from the CPU Unit and perform ON/OFF,
control for external devices.
High-speed Output models CJ1W-OD213 and,
CJ1W-OD234 can help to increase system CS1W-NC113 Installation Guide.
throughput.
Unit type: CS1 Special I/O Units.
Product name: Isolated-type,
Resistance Thermocouple Input Units.
points Input: 8 inputs.
Signal range selection:
Set separately for each input.
I/O type: Pt100, JPt100.
Conversion speed (resolution):
250 ms/8 inputs.
Externa connection: Removable erminal block.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.18A; 26V, 0.06A.
Standards: UC1, CE.
Provides the functionality of isolators,
power supplies, signal converters,
and other devices.
The Analog Input Unit converts analog,
input signals such as 1 to 5 V or 4 to 20mA,
into digital values, and takes the values,
scaled in industrial units, and transfers,
it to the CPU Unit as the process value.
Because of this, no ladder program is required,
at the CPU Unit for scaling.
The Analog Output Unit converts analog output set,
values from the CPU Unit to analog output signals,
such as 4 to 20 mA or 1 to 5 V, and outputs them.
The built-in functions, such as measurement value,
alarms, rate-of-change calculations, and square roots,
have enabled major savings in cost and spaace compared,
with previous systems CS1W-NC113 Manual.
High-resolution Models and 8-point Input Models are,
also available.
By combining the Units, logging/monitoring.
systems can be constructed,
or the Units can be used together with LCBs/LCCUs,
to construct complete process control systems CS1W-NC113 Manual.
Parameters can be easily displayed and set in an,
easy-to-understand form without special tools.