OMRON E3X-NA41F 2M datasheet PDF catalog E3X-NA41F 2M PDF datasheet

The flange plate of the 4CH channel is used to save the space of the vacuum groove.
A one-time installation of optical fiber, a substantial reduction in the number of hours (4CH channel flange).
The two ends of the air side of the fiber can be freely cut, can easily draw back.
The two ends of the side of the optical fiber can be freely cut, can easily draw back E3X-NA41F 2M PDF datasheet.
First screw fastening type 1CH single channel flange E3X-NA41F 2M
When used in high temperature environment, high temperature resistant vacuum optical fiber can be used.
Sensing method: Through-beam type.
Sensing distance(slot width): 3.6 mm.
Output type: NPN output.
Output configuration: Dark-ON.
Cable length: 1 m.
Photomicrosensor with built-in,
amplifier and attached cable reduces,
external light interference E3X-NA41F 2M PDF datasheet.
Light modulation effectively reduces external light interference.
Wide operation voltage range: 5 to 24 VDC.
Easy operation monitoring with bright light indicator. Size: 96 x 96mm.
Control output 1: relay output (open).
Control output 2: relay output (off).
Auxiliary output: 2 points.
Communication mode: RS-485 E3X-NA41F 2M PDF datasheet.
Heater disconnection: -.
Event input: 2.
Power supply voltage: AC100 ~ 240V.
New highlight LCD panel, font larger, display more clearly integrated low power design,
Longer life performance stability,
Perfect function of proportional valve control special (some models have no potentiometer input virtual opening function)
E5AC-PR-800 white LCDPV display height to reach 25mm, greatly improve the visibility.
The main body is short, and the diameter is only 60mm.
50ms high speed sampling period. Size: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes the processs of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E3X-NA41F 2M datasheet PDF catalog.
Through the infrared port can be carried out from the frront of the communication E3X-NA41F 2M datasheet PDF catalog.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.