OMRON E2A-M12LS04-M1-B2 datasheet PDF catalog E2A-M12LS04-M1-B2 PDF datasheet

E3Z-T82-G0 detection methods: the firing pattern.
Connection mode: wire lead out type (2m) 3.
Detection range: 30m.
Output mode: PNP output.
Achieve small, long distance, save electricity and
Standard type of photoelectric sensor for energy saving
Size: 1/16 DIN 48 × 48 × 78 (W × H × D).
Power supply voltage: 24 VAC/VDC E2A-M12LS04-M1-B2 PDF datasheet.
Input type: Analog(current/voltage).
Alarm output: 2 E2A-M12LS04-M1-B2
option units Mounting: Yes.
Control output: Current output.
Previous mode: None.
This Best-selling General-purpose,
48×48-mm Temperature Controller,
Is Now Even Better.
Controllers now available with analog inputs.
Faster sampling at 250 ms.
Transfer output provided for easy output to recorders.
Models available with a loop break alarm (LBA) and,
heater short alarm (HS alarm) E2A-M12LS04-M1-B2 PDF datasheet.
Easy setting with 11-segment displays.
Setting protection indicator informs operator when,
protection is enabled.
Manual output provided.
New protocol called Modbus is installed in the models,
with communications.
USB-Serial conversion cable is available.
Note: Refer to Precautions on page 33. Size: 96 x 96mm.
Type: power AC/DC24V with E2A-M12LS04-M1-B2 PDF datasheet.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-422.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E2A-M12LS04-M1-B2 datasheet PDF catalog.
Through the infrared port can be carried out from the frront of the communication E2A-M12LS04-M1-B2 datasheet PDF catalog.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.