OMRON G70D-VSOC16 Manual G70D-VSOC16 user's manual

Cable with connector (1 to 2) /G79-O_C-_, G79-I_C-_.
L size: A, 1500mm; B, 1250mm.
Input use.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. I/O classification: Counter Unit.
External I/O points: Inputs: 1, Outputs: 2 G70D-VSOC16 user's manual.
I/O connections: Terminal block.
Operating mode: Linear counter G70D-VSOC16
A Counter Unit Supporting Encoder,
Input for Use with MULTIPLE I/O TERMINAL.
High-speed pulse with counting speed of 50 kHz.
Counting can be set to a multiplication factor of 1 or 4.
Wide range of measurement: -8,388,608 to 8,388,607.
One external input and two external outputs are available.
DIN track mounting G70D-VSOC16 user's manual. Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: corresponding (+ public).
Rated voltage: DC24V.
To achieve the control cabinet of miniaturization / save time,
Relay terminal for 8 point output.
Small size of 136 * high 80 * 55mm. (vertical installation)
The total wiring of the connector cable is realized.
The common end can be easily connected with the independent contact and the short circuit piece G70D-VSOC16 user's manual.
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common. Alarm output: 1 output (Heater Burnout Detection,
SSR Short-circuit Failure Detection, Common).
Applicable load (See note.): 2 to 35 A, 200 to 480 VAC.
A New-concept SSR with Built-in.
Current Transformer.
Heater Burnout and SSR Short.
circuit Failure Detection.
Built-in Current Transformer (CT) helps reduce wiring steps.
Detects the burnout of any one of a group of heaters.
Detects the burnout of 3-phaase heaters G70D-VSOC16 Manual.
Detects SSR short-circuit failures.
Error detection level can be easily set with a switch.
Mounts to a DIN track or with screws.
Three types of input terminals available: M3 terminals,
screwless clamp termminals (detachable), or compact slotted,
screw terminals (detachable) G70D-VSOC16 Manual.
Certified for CSA and EN (TÜV).
The G3PF-2@@B-@@@ Series is UL certified.