OMRON E5AC-QR4DSM-000 Manual E5AC-QR4DSM-000 INSTRUCTION Manual

Size: M12 (brass), two - fold range, non - shielded type.
Detection range: 8mm.
Connection mode: lead type (cable length is 2M and 5m two).
Thread length: Standard type.
Output type: NPN.
Action mode NC.
Set up the new standard of the world economy proximity sensor.
OMRON as a pioneer and leader in proximity sensor industry,
Now bring you a new E2B proximity sensor with high performance to price ratio E5AC-QR4DSM-000 INSTRUCTION Manual E5AC-QR4DSM-000
This series of products are complete,
Aimed at reasonable prices to meet customer demand for high quality and high reliability of the sensor.
We have tested the product not only on the protection level (IP67) specific item,
The oil spray test was carried out on the condition of the work site E5AC-QR4DSM-000 INSTRUCTION Manual.
Simulation test was carried out in the environment of high oil mist concentration. Pressure range: Positive pressure; 0 to 1 MPa.
ON/OFF output: Open collector (two independent outputs).
Linear output: 1 to 5 V.
Model: PNP output.
Pressure Sensor with.
Easy-to-Read LED Display.
Pressure status can be checked at a glance from the,
digital display and bar display.
Measurement pressure prevents incorrect outputs due,
to momentary pressure changes E5AC-QR4DSM-000 INSTRUCTION Manual.
Perform automatic teaching simply by teaching pressure,
values for good and bad products.
Industry’s smallest models at just 28 × 28 × 29 mm.
Only in hysteresis mode. The temperature controller with the panel is installed and the infrared ray can be carried out from the front,
Cable for setting tool for communication.
Will be equipped with infrared port E5AN-H/E5EN-H and computer connection,
Can easily set the parameters by CX-Thermo. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makess the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E5AC-QR4DSM-000 Manual.
Through the infrared port can be carried out from the frront of the communication E5AC-QR4DSM-000 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.