OMRON E3T-ST12-M1TJ Manual E3T-ST12-M1TJ INSTRUCTION sheet

Appearance: M12.
Sensing distance: 8 mm.
Connection method: M12 Connector Models .
Cable specifications: --.
Polarity: Yes.
Operation mode : NC.
Pin arrangement: 1: +V, 2: 0 V.
Applicable connector code: D.
Your Search for Proximity Sensors.
Starts with the World-leading.
Performance and Quality of the E2E E3T-ST12-M1TJ INSTRUCTION sheet.
Standard Sensors for detecting ferrous metals E3T-ST12-M1TJ
Wide array of variations. Ideal for a variety of applications.
Models with different frequencies are also available to prevent,
mutual interference.
Superior environment resistance with standard cable made of oil,
resistant PVC and sensing surface made of material that resists,
cutting oil.
Useful to help prevent disconnection E3T-ST12-M1TJ INSTRUCTION sheet.
Cable protector provided as a standard feature. Sensing method: Through-beam.
Connection method: Pre-wired Connector (M8, 4 pins).
Sensing distance: 25 mm.
No. of opti- cal axes: 2.
Model: PNP output.
Photoelectric Sensor with Grooved.
Design and Easy Settings .
Groove-type Sensor with groove width of 25 mm.
Models are available with one or two light axes.
Models are available with M8 pre-wired connectors E3T-ST12-M1TJ INSTRUCTION sheet. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makkes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E3T-ST12-M1TJ Manual.
Through the infrared port can be carried out from the frront of the communication E3T-ST12-M1TJ Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.