OMRON E3S-CD11 Manual E3S-CD11 INSTRUCTION sheet

Size: M12 (brass), single distance, shielding type.
Detection range: 2mm.
Connection mode: lead type (cable length is 2M and 5m two).
Thread length: long thread type.
Output type: PNP.
Action mode NO.
Set up the new standard of the world economy proximity sensor.
OMRON as a pioneer and leader in proximity sensor industry,
Now bring you a new E2B proximity sensor with high performance to price ratio E3S-CD11 INSTRUCTION sheet E3S-CD11
This series of products are complete,
Aimed at reasonable prices to meet customer demand for high quality and high reliability of the sensor.
We have tested the product not only on the protection level (IP67) specific item,
The oil spray test was carried out on the condition of the work site.
Simulation test was carried out in the environment of high oil mist concentration E3S-CD11 INSTRUCTION sheet. Aluminum and Iron Both.
Detectable from Long Distances. High performance price ratio standard type proximity sensor.
Standard cable protector.
The new DC two-wire type.
Non polar proximity sensor.
Type: DC three wire / wire type.
Shape: shield, M12.
Detection range: 2mm.
Output configuration: NPN.
Action mode: NO. Size: 48 x 96mm E3S-CD11 INSTRUCTION sheet.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermoo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E3S-CD11 Manual.
Through the infrared port can be carried out from the frront of the communication E3S-CD11 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.