OMRON E2EQ-X10D1G-M1GJ-T Manual E2EQ-X10D1G-M1GJ-T INSTRUCTION sheet

High performance price ratio standard type proximity sensor.
Standard cable protector.
The new DC two-wire type.
Non polar proximity sensor.
Type: DC three wire / connector type.
Shape: non shield, M30.
Detection range: 18mm.
Output configuration: NPN.
Action mode: NC. Item: Standard models.
Functions: Timer, Response speed change E2EQ-X10D1G-M1GJ-T INSTRUCTION sheet.
Model: PNP output.
Advanced Fiber Amplifier Units E2EQ-X10D1G-M1GJ-T
Features a Power Tuning function that optimizes light,
reception at the press of a button.
APC circuits to suppress LED aging degradation used with,
4-element LEDs.
2-channel models achieve the thinnest* profile in the industry,
at only 5 mm per channel.
2-channel models also offer AND/OR control output E2EQ-X10D1G-M1GJ-T INSTRUCTION sheet.
The E3X-MDA0 with two channels supports an EtherCAT Sensor.
Communications Unit or CompoNet Sensor Communications Unit. Fitting materials: Stainless steel(SUS304).
Count: 1 .
Accessories: Description, Phillips screw Nut plat;
Material, Stainless steel Stainless steel;
Count, 2, 1.
Applicable sensor (mounting pitch on sensor side): ZX1-LD50, ZX1-LD100 @@.
Page: Dimensions, 16.
Size: 96 x 96mm E2EQ-X10D1G-M1GJ-T INSTRUCTION sheet.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes thhe process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E2EQ-X10D1G-M1GJ-T Manual.
Through the infrared port can be carried out from the frront of the communication E2EQ-X10D1G-M1GJ-T Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.