OMRON D4N-8B2H Manual D4N-8B2H INSTRUCTION sheet

Determine the vibration of equipment and machinery.
With the aid of vibration level can be easily recognized, set the ON/OFF output.
Confirm vibration waveform by AC monitor output.
Sensor part of the use of IP67 protection structure, can also be used in harsh environments.
Can switch acceleration, speed (linear output type) D4N-8B2H INSTRUCTION sheet.
Using 5 processing modes to determine the abnormal state of high accuracy (manual setting) D4N-8B2H
Ontology: part of the controller.
Category: linear output. Action force (OF):0.49N (low load action type).
Switch timing: short circuit type.
Drive rod: needle shaped button type.
Super small check switch with push button action type
Super small (6 x 8 x width high depth 4 D4N-8B2H INSTRUCTION sheet. 2mm), light weight (about 0.3 grams), long stroke 3mm.
Short circuit and non short circuit time built-in sliding device capable of selecting switch.
Widely used in small household electrical appliances, audio equipment, office equipment, communication equipment, etc..
Drive rod: ball type.
Terminal specification: solder terminal.
The protection structure is in conformity with the JIS''s anti immersion type, IP67 IEC (except for the terminal part) D4N-8B2H INSTRUCTION sheet.
Can be used in the environment temperature -40 ~ +85.
Through the use of gold alloy bar, contact springs to achieve longevity and high contact reliability. Ratings: 0.1 A.
Actuator: Simulated roller lever.
Terminals: Solder terminals.
Contact form: SPDT.
Sealed Subminiature Basic.
Switch Conforming to IP67.
(Excluding the terminals on terminal models).
Use of epoxy resin assures stable sealing,
making this switch ideal for places subject to,
water spray or excessive dust.
Ideal for automobiles, automatic vending,
machines, refrigerators, ice-making equipment,
bath equipment, hot-water supply systems, air,
conditioners, and industrial equipments, which,
require high environmental resistance.
Models available with UL, CSA, and VDE safety,
standard compliance. Actuator: One-way roller arm lever (horizontal).
Conduit size: 2-conduit; G1/2.
Built-in switch mechanism: 1NC/1NO (Slow-action).
A Series of Pull-reset Models Now.
Available.
Lineup includes three contact models witth 2NC/1NO and 3NC,
contact forms in addition to the previous contact forms 1NC/1NO and 2NC D4N-8B2H Manual.
M12-connector models are available, saving on labor and,
simplifying replacement.
Standardized gold-clad contacts provide high contact reliability D4N-8B2H Manual.
Can be used with both standard loads and microloads.
Conforms to EN115, EN81-1 and EN81-2.
Certified standards: UL, EN (TÜV), and CCC.